question has proposed the initial condition

dima13 · July 12, 2012, 10:24

hello
You could put the final results of some form Be the initial conditions To another form
For example: final result of a bent pipe becomes the initial conditions of a water injector

dima13 · July 14, 2012, 08:03

Can you help me please!

wyldckat · July 14, 2012, 13:14

Hi dima13,

I'm not sure I understand your request, but the closest thing I can think of is the tutorial "incompressible/simpleFoam/pitzDailyExptInlet", where the flow values at the inlet come from a table file, thus giving (I think) a parabolic flow speed at the inlet.

Best regards,
Bruno

July 12, 2012, 10:24	question has proposed the initial condition	#1
dima13 New Member omar_beg Join Date: Mar 2012 Posts: 17 Rep Power: 14	hello You could put the final results of some form Be the initial conditions To another form For example: final result of a bent pipe becomes the initial conditions of a water injector

July 14, 2012, 13:14		#3
wyldckat Retired Super Moderator Bruno Santos Join Date: Mar 2009 Location: Lisbon, Portugal Posts: 10,981 Blog Entries: 45 Rep Power: 128	Hi dima13, I'm not sure I understand your request, but the closest thing I can think of is the tutorial "incompressible/simpleFoam/pitzDailyExptInlet", where the flow values at the inlet come from a table file, thus giving (I think) a parabolic flow speed at the inlet. Best regards, Bruno __________________ OpenFOAM: FAQ \| Getting started Forum: How to get help, to post code/output and forum guide Read this before sending me PM

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Velocity blows up suddenly after 30,000+ iterations	lordvon	OpenFOAM Running, Solving & CFD	15	October 19, 2015 14:52
How to write k and epsilon before the abnormal end	xiuying	OpenFOAM Running, Solving & CFD	8	August 27, 2013 16:33
Differences between serial and parallel runs	carsten	OpenFOAM Bugs	11	September 12, 2008 12:16
Unknown error	sivakumar	OpenFOAM Pre-Processing	9	September 9, 2008 13:53
Modeling in micron scale using icoFoam	m9819348	OpenFOAM Running, Solving & CFD	7	October 27, 2007 01:36

July 14, 2012, 08:03		#2
dima13 New Member omar_beg Join Date: Mar 2012 Posts: 17 Rep Power: 14	Can you help me please!