Transforming output to prescribed format

aerospain · July 10, 2012, 06:42

Hello everyone!

I was wondering if someone has developed a small script to transform OpenFOAM output files, into column formatted files. For example, I would like to be able to read 2D velocity and grid files and create one file with three columns, i.e. X, Y, Speed.

The number of columns could vary, but for an example I think this is self explanatory.

Thanks!

aerospain · July 10, 2012, 07:22

I think I've found a work-around this problem! :-)

I just need someone to confirm my thoughts.

I've opened results in ParaView and "Saved Data" as CSV, and selected "Points" for Field Association in the "Configure Writer" window. Well, seven files have been created, the same number as "Mesh Parts" I have.

My thoughts are that this files correspond one-to-one to the "Mesh Parts" list.

Could anyone confirm this, please?

Thanks!
C.

July 10, 2012, 06:42	Transforming output to prescribed format	#1
aerospain Senior Member aerospain Join Date: Sep 2009 Location: Madrid, Spain Posts: 149 Rep Power: 17	Hello everyone! I was wondering if someone has developed a small script to transform OpenFOAM output files, into column formatted files. For example, I would like to be able to read 2D velocity and grid files and create one file with three columns, i.e. X, Y, Speed. The number of columns could vary, but for an example I think this is self explanatory. Thanks!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fundamental output format control of field values and time	dbxmcf	OpenFOAM	1	January 12, 2011 11:50
surface output format; raw	impecca	OpenFOAM Bugs	2	May 7, 2010 05:16
Mesh Generation Output Format	ali987	ANSYS Meshing & Geometry	1	July 20, 2009 16:35
[Other] Output Format of MetaMesh	t42	OpenFOAM Meshing & Mesh Conversion	0	August 3, 2007 05:28
CCOSILAB -- output data in Excel Format	carlie	Main CFD Forum	0	June 9, 2005 17:11

July 10, 2012, 07:22		#2
aerospain Senior Member aerospain Join Date: Sep 2009 Location: Madrid, Spain Posts: 149 Rep Power: 17	I think I've found a work-around this problem! :-) I just need someone to confirm my thoughts. I've opened results in ParaView and "Saved Data" as CSV, and selected "Points" for Field Association in the "Configure Writer" window. Well, seven files have been created, the same number as "Mesh Parts" I have. My thoughts are that this files correspond one-to-one to the "Mesh Parts" list. Could anyone confirm this, please? Thanks! C.