Error reactingParcelFilmFoam drippingInjection

preibie · April 17, 2012, 06:03

Hallo,

I installed the new version of OF 2.1 and find a mistake. When out of the wall film a water particle should be extracted with the submodel drippingInjection there are no particle in the cloud. In the log file I can see the injected mass (into the 3D fild) but no particles will be created. In the old version 2.0 all was fine. Can help me somebody?

Preibie

A.Devesa · April 18, 2012, 03:33

Hi all,

I observe the same problem. I tried an update, but after compiling the 500+ changed files (since end of december), I could see the same behaviour.

Can anyone assist on that problem? It looks like parcels are somehow generated but then either 1- added to no cloud at all or 2- added to another cloud than the wished one...

Thanks!

preibie · April 19, 2012, 05:33

Hi,

it is an very tricky problem. I send an example which runs very well in the version 2.0.1 and not in the new version of OpenFoam. No particle are separated from the film.

Stefan

A.Devesa · May 2, 2012, 06:32

Hi all,

any update on that?

Thanks,
Antoine

April 17, 2012, 06:03	Error reactingParcelFilmFoam drippingInjection	#1
preibie Member Stefan Join Date: Jun 2009 Posts: 67 Rep Power: 17	Hallo, I installed the new version of OF 2.1 and find a mistake. When out of the wall film a water particle should be extracted with the submodel drippingInjection there are no particle in the cloud. In the log file I can see the injected mass (into the 3D fild) but no particles will be created. In the old version 2.0 all was fine. Can help me somebody? Preibie

April 18, 2012, 03:33	Same problem - no parcels detached but loss of film mass	#2
A.Devesa Member Antoine Devesa Join Date: Mar 2010 Posts: 36 Rep Power: 16	Hi all, I observe the same problem. I tried an update, but after compiling the 500+ changed files (since end of december), I could see the same behaviour. Can anyone assist on that problem? It looks like parcels are somehow generated but then either 1- added to no cloud at all or 2- added to another cloud than the wished one... Thanks! Last edited by A.Devesa; April 18, 2012 at 04:20.

May 2, 2012, 06:32		#4
A.Devesa Member Antoine Devesa Join Date: Mar 2010 Posts: 36 Rep Power: 16	Hi all, any update on that? Thanks, Antoine