|
[Sponsors] |
Dynamically change type of the boundary patch |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 16, 2011, 10:21 |
Dynamically change type of the boundary patch
|
#1 |
Senior Member
|
Hi!
Is it possible to change let's say calculated type to fixedValue or zeroGradient ones for the boundary patch during run-time? I found only constant references so far (no type change is possible). Thank you, waiting for your replies) Regards, Alexander
__________________
Best regards, Dr. Alexander VAKHRUSHEV Christian Doppler Laboratory for "Metallurgical Applications of Magnetohydrodynamics" Simulation and Modelling of Metallurgical Processes Department of Metallurgy University of Leoben http://smmp.unileoben.ac.at |
|
June 16, 2011, 11:00 |
|
#2 |
Senior Member
Sandeep Menon
Join Date: Mar 2009
Location: Amherst, MA
Posts: 403
Rep Power: 25 |
This would probably require you to reset the fvBoundaryMesh definition. You'll have to do a fvMesh::removeFvBoundary(), followed by a fvMesh::addFvPatches(). Of course, each boundary patch needs to be mapped/re-initialized, but with a fixedValue/fixedGradient fvPatch for the calculatedFvPatch that you're looking to replace...
|
|
June 16, 2011, 11:07 |
|
#3 |
Senior Member
|
Thank you Sandeep for such quick response! Now I see...
I am still embarrassed with a power shutdown because of the lightning storm in our town we just had(((
__________________
Best regards, Dr. Alexander VAKHRUSHEV Christian Doppler Laboratory for "Metallurgical Applications of Magnetohydrodynamics" Simulation and Modelling of Metallurgical Processes Department of Metallurgy University of Leoben http://smmp.unileoben.ac.at |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 05:45 |
[Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 15:33 |
Pressure instability with rhoSimpleFoam | daniel_mills | OpenFOAM Running, Solving & CFD | 44 | February 17, 2011 17:08 |
[Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |