 |
 |
 |
|
|
|
[Sponsors] | ||||
How to remove the fiction on the interface in interFoam? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 6, 2011, 05:34
|
How to remove the fiction on the interface in interFoam?
|
#1 |
|
New Member
Tong Zhongyao
Join Date: Oct 2010
Posts: 10
Rep Power: 16  |
Hi everyone,
The problem I confront when I use interFoam is: the velocity of the gas phase is much too big so the timestep has to be very small (to keep courant number <1), that wastes me a lot of time. In fact, gas phase has little influence on the simulation. So can anyone tell me how to remove the fiction on the interface? Best wishes! tong |
|
|
|
|
|
| Tags |
| fiction, freesurface, interface, interfoam |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
| interFoam - stratified flow - problem with shear stress at interface | AnjaMiehe | OpenFOAM Running, Solving & CFD | 8 | June 14, 2010 07:49 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
| Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 21:09 |
Linear Mode
