|
[Sponsors] |
I lose some fluid during simulation using InterDyMFoam |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 20, 2010, 16:19 |
I lose some fluid during simulation using InterDyMFoam
|
#1 |
Member
angel
Join Date: May 2009
Location: Spain
Posts: 46
Rep Power: 17 |
Hello,
I'm trying to simulate fluid sloshing inside a tank with InterDyMFoam, subjected to a sinusoidal lateral displacement. I start at 0,05 sec and stop at 58 sec. After that the fluid oscillates freely. When i use the patchIntegrate p walls to obtain the vertical, I obtain a curve that start from -323 N a 0 sec but at the end of my simulation I don't obtain the same value. It seems like if I lose some fluid during the simulation, probably by the solution convergence. Can anybody tell me what is the reason to this effect, result_Fx_Fy.jpgthank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
air bubble is disappear increasing time using vof | xujjun | CFX | 9 | June 9, 2009 08:59 |
Expert parameter to stop the fluid flow simulation | KK | CFX | 1 | February 25, 2008 17:29 |
how to use fluid fluid interface | Beno | CFX | 0 | July 13, 2005 15:08 |
Impact simulation of container filled with fluid | worasit | CFX | 0 | April 21, 2004 14:53 |
3-D Contaminant Dispersal Simulation | Apple L S Chan | Main CFD Forum | 1 | December 23, 1998 11:06 |