 |
 |
 |
|
|
|
[Sponsors] | ||||
February 12, 2010, 16:53
|
Specify wall point
|
#1 |
|
New Member
Kyungrock Kim
Join Date: Jun 2009
Posts: 20
Rep Power: 17  |
Dear Formers
I just want to specify wall point in any geometries so that specify blending point between two models, say (y_ - wall point). (y_ - wall point) might be half of height from at each wall. How should I do it in this case? Thanks in advance Kyungrock |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] StitchMesh on two patches | anita | OpenFOAM Meshing & Mesh Conversion | 31 | April 4, 2013 12:51 |
| Creating a mass point source on a boundary (say, wall) or in Interior (for tracer) | mixer | OpenFOAM Running, Solving & CFD | 3 | August 19, 2009 10:39 |
| Question about bcdefw.f for wall temperature bc. | Jimmy | Siemens | 10 | March 18, 2008 16:28 |
| Deal with wall boundary with moving mesh by FVM? | aiya | Main CFD Forum | 6 | May 10, 2007 12:33 |
| Estimation of First Grid Point Near Wall | Amer Mahmood | FLUENT | 2 | April 25, 2006 12:49 |
Linear Mode
