Heat transer problem - boundary condition

dVoglander · March 31, 2009, 06:47

Hi,

for heat transfer problems, i have used untill now two types of boundary conditions for the temperature: imposed value or imposed gradient.

Actually, i would like to impose a heat transfer coefficient which would be used to calculate the heat flux, based on a exterior temperature for example. The heat flux at the boundary would depend on the temperature calculation at the boundary. This can be a more realistic boundary condition for some cases.

Is there something in OpenFoam to do that?

Thank you

dVoglander · April 1, 2009, 11:30

Hi all,

me again....

Is the boundary condition wallHeatFlux from version 1.3 (i think) still available in OpenFOAM 1.4 or 1.5? If not, what replaces it?

Thank you

March 31, 2009, 06:47	Heat transer problem - boundary condition	#1
dVoglander New Member Dirk Voglander Join Date: Mar 2009 Posts: 5 Rep Power: 17	Hi, for heat transfer problems, i have used untill now two types of boundary conditions for the temperature: imposed value or imposed gradient. Actually, i would like to impose a heat transfer coefficient which would be used to calculate the heat flux, based on a exterior temperature for example. The heat flux at the boundary would depend on the temperature calculation at the boundary. This can be a more realistic boundary condition for some cases. Is there something in OpenFoam to do that? Thank you

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Boundary condition problem for open channel flow	Andy	CFX	9	June 11, 2016 08:20
UDS problem with wall boundary condition	Alex F.	FLUENT	15	September 21, 2015 10:28
a special boundary condition problem!!	hillriver	FLUENT	2	October 17, 2005 10:07
boundary condition for Heat Transfer	sylvain	Main CFD Forum	4	June 30, 2005 16:26
a problem with Boundary condition	M Rad	Main CFD Forum	12	November 27, 1998 13:49

April 1, 2009, 11:30		#2
dVoglander New Member Dirk Voglander Join Date: Mar 2009 Posts: 5 Rep Power: 17	Hi all, me again.... Is the boundary condition wallHeatFlux from version 1.3 (i think) still available in OpenFOAM 1.4 or 1.5? If not, what replaces it? Thank you