 |
 |
 |
|
|
|
[Sponsors] | ||||
February 3, 2006, 19:06
|
I saw some mesh refinement dis
|
#1 |
|
Senior Member
Xiaofeng Liu
Join Date: Mar 2009
Location: State College, PA, USA
Posts: 118
Rep Power: 17  |
I saw some mesh refinement discussion. It seems that the mesh coarsen is more difficult to implement.
simple question: how to merge two cells? I found something on removing a cell, but this will kick the cell out of the mesh. Anybody got some idea?
__________________
Xiaofeng Liu, Ph.D., P.E., Assistant Professor Department of Civil and Environmental Engineering Penn State University 223B Sackett Building University Park, PA 16802 Web: http://water.engr.psu.edu/liu/ |
|
|
|
|
|
February 6, 2006, 05:50
|
Check out the removeFaces appl
|
#2 |
|
Senior Member
Mattijs Janssens
Join Date: Mar 2009
Posts: 1,419
Rep Power: 26 |
Check out the removeFaces application in mesh/advanced.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Create fine mesh that grows to coarse mesh (Urgent | CZ | FLUENT | 1 | January 3, 2009 11:36 |
| Oscillatory mesh motion setup mesh flux ERROR | jaswi | OpenFOAM Running, Solving & CFD | 5 | August 23, 2007 05:41 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |
| dynamic mesh - structured or cooper mesh | Manoj Kumar | FLUENT | 2 | November 11, 2005 02:18 |
| Coarsen 3D Grid ?? | Stephen | FLUENT | 0 | March 17, 2005 06:14 |
Linear Mode
