|
[Sponsors] |
September 4, 2007, 14:24 |
This forum thread is working i
|
#1 |
Guest
Posts: n/a
|
This forum thread is working its way through the internet forum boards like a plague. I figured maybe someone here could help this guy with some computer analysis of his modification.
http://www.mx6.com/forums/2g-mx6-for...turbo-mod.html (must see to believe, don't wet pants laughing) If you need a good laugh read through the posts. If you want a condensed list of posts from the original poster go to the bottom of the page here. http://www.copexturbo.com/ my favorite quote "Note: Boosting fine, still no shaft play in any direction and with the engine @ Idle(650rpm) the turbo can spin fast enough that there's no way to stop it with bare hands." |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help needed Centrifugal compressor problem | Raghavendra.M | FLUENT | 0 | December 24, 2008 00:44 |
Axial Compressor CFD-Help needed | Pankaj | CFX | 1 | April 29, 2008 14:29 |
Turbo Noise analysis | Pankaj | CFX | 1 | August 8, 2007 10:56 |
structural analysis of compressor blades... | mani | FLUENT | 1 | May 2, 2007 08:05 |
axial compressor -aerofoil analysis | richard | Main CFD Forum | 1 | November 1, 2002 09:15 |