 |
 |
 |
|
|
|
[Sponsors] | ||||
June 9, 2008, 11:09
|
Hi foamers
I plotted the vect
|
#1 |
|
New Member
Daniela
Join Date: Mar 2009
Location: Italy
Posts: 4
Rep Power: 17  |
Hi foamers
I plotted the vectors of the flow velocity as written on page U-29 (tutorials) and the image I got was the same as that appearing in Figure 2.11 (page U-30). Are the vectors on the left and right side correct? Why are these vectors horizontal? i think they should be tangent to the walls... |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM] ParaFOAM issue with cavity case | mschoenberg | ParaView | 3 | November 21, 2008 04:57 |
| k din't converge for Lid Driven Cavity case | Adrian | FLUENT | 1 | October 24, 2008 06:11 |
| [OpenFOAM] ParaFoam problem with cavity case | roger | ParaView | 9 | September 16, 2008 23:00 |
| Glyph command to close GRIDGEN? | chris | Pointwise & Gridgen | 2 | March 25, 2007 15:22 |
| Problems reading a case cavity into paraFoam red hat 9 | anton322322 | OpenFOAM Pre-Processing | 0 | April 11, 2005 14:13 |
Linear Mode
