[isabel]

In this link you have the discretization of pEqn.H in sonicFoam, buoyantFoam and interFoam:

http://www.cfd-online.com/Forums/ope...o-details.html

For interPhaseChangeFoam is similar to interFoam.

[sandy]

Originally Posted by isabel

Thank you very much, sandy. In the interPhaseChangeFoam, the terms vDotcP and vDotvP are divided by the pressure, so when you solve the continuity equation, you multiply for the pressure again to have the units 1/s.

Then, my equation which is

div(U) = source

in pEqn.H of the interPhaseChangeFoam solver would be typped as:

fvScalarMatrix pEqn
(
fvc::div(phi) - fvm::laplacian(rUAf,pd) - source
);


Am I wright?

div(U) = (vDotcP-vDotvP) * (p - pSat)

So, to pEqn of interPhaseChangeFoam, the Sp of source term is {(vDotcP-vDotvP) * p} and Su is {-(vDotcP-vDotvP) * pSat}.

However, in pEqn.H, the U is the face volume flux phi instead of the velocity U, why we need not intepolate the RHS too?

[ak2009]

Hello Bitan,

I am working on surface aeration. We have tried with LES in fluent. want to apply the level set method to study the interface behavior in openfoam.

I came across the link to below paper. Would it be possible to refer to this paper ?

Implementation of level set method based on OpenFOAM for Capturing the free interface in incompressible fluid flows.

[ak2009]

can anyone suggest about the use of VOSET in fluent

[ak2009]

I am working on surface aeration. We have tried with LES. want to apply the level set method to study the interface behavior. We are using openfoam.

I came across the link to below paper. Would it be possible to refer to this paper ?

Implementation of level set method based on OpenFOAM for Capturing the free interface in incompressible fluid flows

my email address is akforu2000@yahoo.co.in

[karthik1414]

hello all,
I am new to openfoam, and can anyone give me advice on how to use BasicThermo.C in Interfoam??
Basically, i want to vary density and temperature with change in pressure, in a two-phase vof problem.
it would be a great help if anyone would give me advice on this!!
thank you,
warm regards,
Karthik

[ehsan]

Dear All

May I ask you which VOF model has been used in OF? Is it Youngs, Hirt and Nichols, or another VOF method?

Thanks
Ehsan

[Harikrishnan]

Which equations are to be solved for the simulation of a flow boiling case????????

[Sasy]

Hi Foamers,
i want simulate evaporation in vertical tube,i use interFoam solver,and i know should modify by adding T.eqn and mass source..but i dont know how??plz help...

[Mosayeb]

Hi everyone!

Could you please email me this paper:
Implementation of level set method based on OpenFOAM for Capturing the free interface in incompressible fluid flows

my email: mashpot139@gmail.com

thanks