Error when converging when Mesh is slightly changes -- CFD Online Discussion Forums

May 15, 2024, 18:38	Error when converging when Mesh is slightly changes	#1
Leo Laurer New Member Join Date: May 2024 Posts: 1 Rep Power: 0	I am simulating a laminar flow at Re=1e6 with free stream velocity ~0.1, water kinematic viscosity 0.984e-6 and length of wall 10m. This is the simulated flow: I have a very simple Mesh at the moment as shown here: And if I increase any of the Mesh values by any amount the simulation no longer converges and I have no idea why this occurs. This is my controlDict: I have a U=[0.984 0 0] boundary condition at the inlet and a pressure =0 at outlet. If anyone has any idea why it might not be converging any advice would be useful!

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to perform larger deformations while mantaining good mesh with adjoint solver	FormulaStudentFEB	STAR-CCM+	0	October 13, 2023 12:27
flow over cylinder in openFoam	saeed jamshidi	OpenFOAM Pre-Processing	3	August 11, 2023 16:16
[snappyHexMesh] SnappyHexMesh/splitMeshRegion : region1 in zone "-1"	GuiMagyar	OpenFOAM Meshing & Mesh Conversion	3	August 4, 2023 13:38
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
Mesh motion with Translation & Rotation	Doginal	CFX	2	January 12, 2014 07:21

All times are GMT -4. The time now is 13:42.