 |
 |
 |
|
|
|
[Sponsors] | ||||
March 27, 2024, 13:35
|
Foam Fatal Error
|
#1 |
|
New Member
Muhammed Shafeeh K
Join Date: Apr 2023
Posts: 3
Rep Power: 3  |
when I am running propeller simulation in open foam using pimpleFoam solver I am facing an error
-------------------------------------------------------------------------- [5] [5] [5] --> FOAM FATAL IO ERROR: (openfoam-2312) [5] No matching cellZones: innerCylinderSmall Valid zones : () Valid groups: () [5] [5] [5] file: stream at line 0. [5] [5] From Foam::zoneMotion::zoneMotion(const Foam::dictionary&, const Foam:  olyMesh&)[5] in file motionSolvers/displacement/displacement/zoneMotion.C at line 90. [5] FOAM parallel run exiting how I can resolve this error, thanks in advance |
|
|
|
|
|
March 27, 2024, 15:14
|
|
#2 |
|
Senior Member
M
Join Date: Dec 2017
Posts: 703
Rep Power: 13 |
Have you tried ... reading the error message?
|
|
|
|
|
|
|
March 27, 2024, 19:24
|
|
#3 |
|
New Member
Muhammed Shafeeh K
Join Date: Apr 2023
Posts: 3
Rep Power: 3 |
first I am an absolute beginner in openfoam and I found that there is no cell zone in constant/polyMesh/cell zone, how do I add that
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM] ParaView command in Foam-extend-4.1 | mitu_94 | ParaView | 0 | March 4, 2021 14:46 |
| Mesquite - Adaptive mesh refinement / coarsening? | philippose | OpenFOAM Running, Solving & CFD | 94 | January 27, 2016 10:40 |
| Compiling dynamicTopoFvMesh for OpenFOAM 2.1.x | Saxwax | OpenFOAM Installation | 25 | November 29, 2013 06:34 |
| checking the system setup and Qt version | vivek070176 | OpenFOAM Installation | 22 | June 1, 2010 13:34 |
| Version 15 on Mac OS X | gschaider | OpenFOAM Installation | 113 | December 2, 2009 11:23 |
Linear Mode
