|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
GaspA
Join Date: Jan 2023
Location: Switzerland - Valais
Posts: 5
Rep Power: 3 ![]() |
Hello foamers,
I have two general questions regarding NCCs in OF11: 1) How can we replace the cyclicAMI (periodic) condition with the following characteristics: type cyclicAMI; neightbourPatch XY; transform rotational; rotateAxis (0 0 1); rotateCenter (0 0 0); Using NCCs? This question because cyclicAMI no longer exists in OF11. 2) I cannot launch a simulation if I execute the 'renumberMesh' command after decomposing the calculation ('decomposePar'), if the calculation contains NCCs ('createNonConformalCouples'). If the 'renumberMesh' command is run before decomposition, it works.Do you know anything about this? I thank you for your help. GaspA |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
NCC - renumberMEsh and periodic cyclicAMI | GaspA | Main CFD Forum | 1 | January 5, 2024 06:05 |
Loss of mesh orthogonal quality after using renumberMesh | a.aralnu | OpenFOAM | 4 | October 29, 2021 10:56 |