|
[Sponsors] |
July 5, 2023, 07:49 |
Enabling chemistry only in a zone (Simflow)
|
#1 |
New Member
Louis Collignon
Join Date: Jul 2023
Posts: 1
Rep Power: 0 |
Hello everyone,
I apology in advance if this post is not in the right section. I'm new on simflow and before getting lost in the numerous options of the software, I'd like to know if it's possible to enable chemistry only in a zone of the volume. I try to model a catalyst bed, which leads to heat generation, which stops at the end of the bed. Basically I want to model a flow entering a porous reactive media, exiting as a simple flow. Thank you everyone ! |
|
Tags |
reacting flows, simflow help |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Problem with Mesh conversion from FLUENT Meshing to OpenFOAM | mn17jyf | OpenFOAM Meshing & Mesh Conversion | 3 | November 1, 2023 10:49 |
Illegal cell label -1, fluent3DMeshToFoam | BenGher | OpenFOAM | 7 | October 10, 2023 01:02 |
PEMFC tutorial case problem | Suleyman41 | FLUENT | 2 | July 15, 2023 12:16 |
Averaging over iterations for steady-state simulation | CFD student | Fluent UDF and Scheme Programming | 8 | September 22, 2022 04:39 |
Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 10:28 |