|
[Sponsors] |
chtMultiRegionSimpleFoam temperature artifacts |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Max Spencer
Join Date: Dec 2019
Posts: 11
Rep Power: 6 ![]() |
I am facing issues getting my cht simulation to run without blowing up at various places in the mesh which change refinement levels. I am using SHM which is meshing okay. My results run but I have to limit the temperatures (via fvOptions) to keep from errors due to negative temperatures.
Attached is a picture of one such place in a solid domain. In the _points picture the upper and lower temperatures at at the limits (300 lower, 370 upper). In the _cell picture the issue is not as apparent. I cannot run a uniform cell refinement across the domain due to size limitations. I have tried with various combinations of relaxation in the fluid and solid domains without good success. I have 6 solid domains and 1 fluid domain. Any suggestions or techniques to manage this better or help prevent it from happening? Solver is chtMultiRegionSimpleFoam. temp_artifact_cell_data.jpg temp_artifact_point_data.jpg |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Outlet temperature to temperature boundary condition of velocity inlet. (UDF) | dillon | Fluent UDF and Scheme Programming | 3 | March 25, 2018 11:06 |
Static temperature and Total temperature | Jong-Yoon | FLUENT | 0 | September 25, 2016 01:42 |
Free stream temperature | saharesobh | FLUENT | 1 | October 11, 2012 20:52 |
How to get free stream temperature in boundary condition | saharesobh | FLUENT | 0 | October 9, 2012 17:12 |
monitoring point of total temperature | rogbrito | FLUENT | 0 | June 21, 2009 17:31 |