|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Chaitanya kishore
Join Date: Jun 2021
Posts: 9
Rep Power: 5 ![]() |
Hi everyone.
I am beginner in openfoam, simulating a steady state conjugate heat transfer problem. In this simulation, the residuals are decreasing up to some point, then they are oscillating periodically. I couldn't able to understand why this is happening. Please explain if anyone knew about this phenomenon. The residual graph is attached here. Last edited by kishore208; June 20, 2022 at 04:53. Reason: picture is not attached properly |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Oscillating residuals. Is it okay? | Ana Herrero | Main CFD Forum | 6 | September 19, 2020 14:36 |
how to avoid residuals oscillating? | Weiqiang Liu | FLUENT | 8 | June 2, 2020 11:53 |
Reason for oscillating residuals | fayaazhussain | Main CFD Forum | 3 | August 21, 2014 10:31 |
Oscillating residuals and no convergence! | Sherlock_1812 | OpenFOAM Running, Solving & CFD | 7 | August 20, 2014 09:39 |
Oscillating Residuals in Finer Mesh Case | Jake | FLUENT | 3 | June 16, 2005 09:34 |