 |
 |
 |
|
|
|
[Sponsors] | ||||
June 19, 2022, 06:56
|
2 Different "chechMesh" results
|
#1 |
|
Senior Member
Sakun
Join Date: Nov 2019
Location: United Kingdom
Posts: 152
Rep Power: 7  |
Hi guys,
I have a 2D compressor blade mesh from ICEM and I’m trying to simulate this case in 2 different systems which are Linux (pic.1) and windows (WSL) (pic.2)but when I use ”checkMesh” command in each systems I get 2 different results for non orthogonality as shown in the pictures. non orthogonality is fully based in the blade according to the OpenFoam in windows. I used same 0, constant, system and mesh file, also both systems have the same OpenFoam version which is v2112 Much appreciate for any help 
|
|
|
|
|
 |
| Tags |
| 2d case, check mesh, compressible flow problem |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Time sensitivity analysis - results variation | qntldoql | FLUENT | 1 | January 25, 2022 01:07 |
| My results become inconsistent when using PIMPLE (nOuterCorrectors>1) instead of PISO | FloB | OpenFOAM Running, Solving & CFD | 5 | May 17, 2021 07:17 |
| lid driven cavity varying results | yasmil | OpenFOAM Running, Solving & CFD | 2 | October 6, 2016 22:42 |
| interFoam simulation yields inconsistent results for alpha1 surface | Ralinus | OpenFOAM Running, Solving & CFD | 8 | January 13, 2014 09:54 |
| Different Results from Fluent 5.5 and Fluent 6.0 | Rajeev Kumar Singh | FLUENT | 6 | December 19, 2010 12:33 |
Linear Mode
