[IgnacioJohannesen]

Hello everyone,

I'm new in CFD and OpenFoam, so probably this question will be a little bit dum!
I was working with different versions of my case, using different wallfunctions, meshes and turbulence models.
I usually setup my case and I used mapFields function to start from a already developed flow from another of my cases that have a good result.

my question is: when I use mapFields, do the wallfunctions (for example for k and omega) change or remain as in the new case? I ask that because looking at my mapped cases, the k and omega files do not show the wallfunctions.

regards,