 |
 |
 |
|
|
|
[Sponsors] | ||||
October 31, 2020, 08:22
|
symmety plane acts like wall on fluid
|
#1 |
|
New Member
David Dudli
Join Date: Oct 2020
Location: Switzerland
Posts: 8
Rep Power: 5  |
Hi CFDealers
 Im setting up my first OF-case (water flowing through symmetric vessel with in- and outlet). After simulating the fluid seems to react to my symmetry plane like to a wall (Paraview picture: Outlet and symmetry plane on the left). Is there something wrong with my setup or should I increase simulation time (10 s by now)? I attached the pic and also my U-file Thanks in advance |
|
|
|
|
 |
| Tags |
| boundary condition u, simplefoam, symmetry plane |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Setting the height of the stream in the free channel | kevinmccartin | CFX | 12 | October 13, 2022 21:43 |
| Error in Two phase (condensation) modeling | adilsyyed | CFX | 15 | June 24, 2015 19:42 |
| Setting rotating frame of referece. | RPFigueiredo | CFX | 3 | October 28, 2014 04:59 |
| An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |
| Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
Linear Mode
