 |
 |
 |
|
|
|
[Sponsors] | ||||
September 14, 2020, 04:28
|
cyclic BC only for some variables
|
#1 |
|
Senior Member
Gerry Kan
Join Date: May 2016
Posts: 376
Rep Power: 11  |
Howdy Foamers:
I would like to ask question before considering implementing a new boundary condition for it. My domain has two cyclic boundaries, where flow out in one of the cyclic boundaries will be fed back to the other cyclic boundary. However, I would like to prevent other variables (e.g., species) from feeding back. I could contemplate writing a new boundary condition where cyclic is applied to velocity only, and everything else will be set to zeroGradient, but before I do that I would like to know if there already exists a way to do this in OpenFOAM. Thanks in advance, Gerry. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Optimal tolerance and variables scaling settings | 4513645ygq | Main CFD Forum | 0 | July 28, 2020 09:56 |
| Cyclic boundary condition in foam-extend 4.0 | rellumeister | OpenFOAM Pre-Processing | 2 | March 3, 2020 09:03 |
| time step continuity error increases with time_SRFSimplefoam | mostafa kamal | OpenFOAM Running, Solving & CFD | 7 | October 2, 2019 03:00 |
| LES in OF 3.0.1, no Output for nuSgs | Mirage | OpenFOAM Programming & Development | 1 | October 4, 2016 19:00 |
| Possible createPatch/createBaffles bug? | simpomann | OpenFOAM Bugs | 2 | July 15, 2014 08:07 |
Linear Mode
