 |
 |
 |
|
|
|
[Sponsors] | ||||
Openfoam synthetic jet for cylinder drag reduction |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 16, 2020, 19:31
|
Openfoam synthetic jet for cylinder drag reduction
|
#1 |
|
New Member
Suraj Pawar
Join Date: Sep 2013
Posts: 10
Rep Power: 13  |
I am new to OpenFoam and would like to do the numerical simulation of flow over the cylinder. I would like to use synthetic jets on the cylinder where I can specify the mass flow rate and velocity profile of the flow. The purpose of these synthetic jet is to reduce the drag using some control strategy. Is there any tutorial or paper that I can refer to for creating artificial synthetic jets? I could not find how to create synthetic jets in the documentation. I have attached the illustrative figure in which I would like to specify the jet at red lines.
Thank you. |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Drag Force Ratio for Flat Plate | Rob Wilk | Main CFD Forum | 40 | May 10, 2020 05:47 |
| OpenFOAM course for beginners | Jibran | OpenFOAM Announcements from Other Sources | 2 | November 4, 2019 09:51 |
| OpenFOAM Training Jan-Jul 2017, Virtual, London, Houston, Berlin | CFDFoundation | OpenFOAM Announcements from Other Sources | 0 | January 4, 2017 07:15 |
| inclined synthetic jet | Marouane Dghim | Main CFD Forum | 0 | July 15, 2008 10:41 |
| drag reduction techniques???? | vijesh joshi | Main CFD Forum | 1 | May 8, 2006 18:26 |
Linear Mode
