 |
 |
 |
|
|
|
[Sponsors] | ||||
June 2, 2020, 09:43
|
Propeller under bollard pull conditions
|
#1 |
|
New Member
LouisDS
Join Date: Dec 2019
Posts: 12
Rep Power: 6  |
Dear OpenFOAM users,
Is there someone who has experience with simulating a ship or propeller under bollard pull conditions. In the literature, many authors are writing that it is impossible as OpenFOAM always needs an inlet velocity. Is this true? Because I am experiencing difficulties with the boundary conditions and convergence for this kind of simulation. ( I am using a simpleFoam solver) Thanks in advance and kind regards, Loewieke |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
| Error with snappyHexMesh when using another propeller in propeller tutorial | quarkz | OpenFOAM Running, Solving & CFD | 4 | May 24, 2021 16:59 |
| Wrong multiphase flow at rotating interface | Sanyo | CFX | 14 | February 7, 2017 18:19 |
| motion constraints for a boat moved by propeller | simon-2 | OpenFOAM Running, Solving & CFD | 0 | September 14, 2015 17:28 |
| Boundary Conditions for a Propeller | Orb | Main CFD Forum | 0 | November 18, 2012 02:23 |
Linear Mode
