|
[Sponsors] |
September 23, 2019, 06:51 |
Solver selection
|
#1 |
New Member
Srikar
Join Date: Sep 2019
Posts: 14
Rep Power: 7 |
Hi,
I want to run a conjugate heat transfer analysis on an incompressible, laminar and steady state flow. Is "chtMultiRegionSimpleFoam" the right solver? |
|
September 23, 2019, 11:41 |
|
#2 |
Senior Member
Herpes Free Engineer
Join Date: Sep 2019
Location: The Home Under The Ground with the Lost Boys
Posts: 931
Rep Power: 13 |
Might be: chtMultiRegionSimpleFoam.
Turn off turbulence in constant/turbulenceProperties if you don't want turbulence model involvement.
__________________
The OpenFOAM community is the biggest contributor to OpenFOAM: User guide/Wiki-1/Wiki-2/Code guide/Code Wiki/Journal Nilsson/Guerrero/Holzinger/Holzmann/Nagy/Santos/Nozaki/Jasak/Primer Governance Bugs/Features: OpenFOAM (ESI-OpenCFD-Trademark) Bugs/Features: FOAM-Extend (Wikki-FSB) Bugs: OpenFOAM.org How to create a MWE New: Forkable OpenFOAM mirror |
|
Tags |
chtmultiregionsimplefoam, incompressible, laminar, openfoam v5, steady state |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Floating Point Exception Error | nyox | FLUENT | 11 | November 30, 2018 13:31 |
[ANSYS Meshing] Help with element size | sandri_92 | ANSYS Meshing & Geometry | 14 | November 14, 2018 08:54 |
fluent divergence for no reason | sufjanst | FLUENT | 2 | March 23, 2016 17:08 |
Solver selection for transonic compressor stage in Foam-extend-3.0 | dowlee | OpenFOAM Running, Solving & CFD | 1 | April 16, 2015 14:33 |
Problem in3D model processing | mebinitap | OpenFOAM | 2 | December 12, 2014 05:40 |