|
[Sponsors] |
Help with Boundary conditions for a two phase simulation. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 10, 2019, 07:31 |
Help with Boundary conditions for a two phase simulation.
|
#1 |
New Member
Florian
Join Date: Dec 2018
Posts: 20
Rep Power: 8 |
Hello there,
i'm running a 2phase simulation (Water and Air) on a Hydrofoil wing. It took me a while but i finally managed to get it to converge on a value that makes sense and is pretty close to reality. Now i wanna check how the wing performs when angled 1° up and down. All i changed was the arrangement of parts in the mesh. Mesh settings with influencebodies remain the same yet now the cases keep diverging again. For the 0° simulation the fix seemed to be making the Boundaryconditions at the outlet more restrictive. I went from ZeroGradient for U, p_rgh and water to having u and water be fixedValues and p_rgh as fixedFluxPressure. I kept those conditions the same for the -1° and +1° simulations yet they keep diverging. Does anyone have an idea what else i could try? CheckMesh only returns 3 high orthogonality faces out of 23million cells and says "Mesh OK" in general. I'd be very grateful for some help. |
|
Tags |
boundary conditions, convergence, divergence, ltsinterfoam |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 18:30 |
Overflow Error in Multiphase Modelling with Two Continuous Fluids | ashtonJ | CFX | 6 | August 11, 2014 15:32 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 18:11 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 07:28 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 08:00 |