 |
 |
 |
|
|
|
[Sponsors] | ||||
February 22, 2019, 14:22
|
Parallel running
|
#1 |
|
Member
shima
Join Date: Feb 2018
Posts: 58
Rep Power: 8  |
Hi,
I am using olaFlow for my simulation, when I want to run it parallel, I use decomposePar command. then if I start submitting the job and start simulation, it does not work! I think after decomposing I have to run setFeilds again; but, I do not know what is the command for parallel run instead of setFeilds? Can anyone please help me through this? Best, Shima. |
|
|
|
|
|
February 23, 2019, 04:14
|
|
#2 |
|
Senior Member
Francesco Del Citto
Join Date: Mar 2009
Location: Zürich Area, Switzerland
Posts: 237
Rep Power: 18 |
Like for the solver, use
mpirun -np # setFields -parallel [other options] Run setFields -help or read the manual for more info about parallel runs. Hope this help, Francesco |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] blueCFD-Core-2016 user compiled solvers not running in parallel | sbence | OpenFOAM Installation | 10 | December 5, 2018 09:44 |
| Error running openfoam in parallel | fede32 | OpenFOAM Programming & Development | 5 | October 4, 2018 17:38 |
| error while running in parallel using openmpi on local mc 6 processors | suryawanshi_nitin | OpenFOAM | 10 | February 22, 2017 22:33 |
| Fluent 14.0 file not running in parallel mode in cluster | tejakalva | FLUENT | 0 | February 4, 2015 08:02 |
| Problems running in parallel - missing controlDict | Argen | OpenFOAM Running, Solving & CFD | 4 | June 7, 2012 04:50 |
Linear Mode
