SprayFoam droplet size tracking/ reading

Arslo · July 2, 2018, 07:30

Hello everyone,

I modified the aachenbomb case for a project. To verify my simulation I need to read out the droplet size of the injected fluid at a specific place.
I searched for a similar project but I could just find the "regionSizeDistribution" but that just works for "twoPhaseEulerFoam".
Does anyone know how to accomplish that?
An example case would help a lot.

With size, I mean diameter of the droplets.

Thank you!

HPE · March 27, 2020, 13:23

"regionSizeDistribution" should work with your case, it is not limited to that particular solver.

July 2, 2018, 07:30	SprayFoam droplet size tracking/ reading	#1
Arslo New Member Join Date: Jun 2018 Posts: 1 Rep Power: 0	Hello everyone, I modified the aachenbomb case for a project. To verify my simulation I need to read out the droplet size of the injected fluid at a specific place. I searched for a similar project but I could just find the "regionSizeDistribution" but that just works for "twoPhaseEulerFoam". Does anyone know how to accomplish that? An example case would help a lot. With size, I mean diameter of the droplets. Thank you! Last edited by Arslo; July 2, 2018 at 09:15.

March 27, 2020, 13:23		#2
HPE Senior Member Herpes Free Engineer Join Date: Sep 2019 Location: The Home Under The Ground with the Lost Boys Posts: 931 Rep Power: 13	"regionSizeDistribution" should work with your case, it is not limited to that particular solver. __________________ The OpenFOAM community is the biggest contributor to OpenFOAM: User guide/Wiki-1/Wiki-2/Code guide/Code Wiki/Journal Nilsson/Guerrero/Holzinger/Holzmann/Nagy/Santos/Nozaki/Jasak/Primer Governance Bugs/Features: OpenFOAM (ESI-OpenCFD-Trademark) Bugs/Features: FOAM-Extend (Wikki-FSB) Bugs: OpenFOAM.org How to create a MWE New: Forkable OpenFOAM mirror

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
decomposePar problem: Cell 0contains face labels out of range	vaina74	OpenFOAM Pre-Processing	37	July 20, 2020 06:38
OF 1.6 \| Ubuntu 9.10 (64bit) \| GLIBCXX_3.4.11 not found	piprus	OpenFOAM Installation	22	February 25, 2010 14:43
Problems in compiling paraview in Suse 10.3 platform	chiven	OpenFOAM Installation	3	December 1, 2009 08:21
[Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA,	cfdproject	OpenFOAM Meshing & Mesh Conversion	0	April 14, 2009 16:45
Phase locked average in run time	panara	OpenFOAM	2	February 20, 2008 15:37