problem with AMI + patchMeanVelocityForce -- CFD Online Discussion Forums

June 20, 2018, 10:53	problem with AMI + patchMeanVelocityForce	#1
gorgon New Member GD Join Date: Nov 2010 Location: Rome Posts: 3 Rep Power: 15	Hello guys, I'm running a case with periodic in/out with cyclicAMIs at inflow and outflow with identical inflow / outflow surfaces (and obviously the same area) The mass flow rate is specified through a patchMeanVelocityForce fvOption and the MRF is active as well The problem is that I get the usual problem: --> FOAM FATAL ERROR: Continuity error cannot be removed by adjusting the outflow. Total flux : 5.6995106 Specified mass inflow : 0.0001926572 Specified mass outflow : 0.000192735712 Adjustable mass outflow : 0 any ideas? thanks in advance __________________ GD

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fluent Parallelization Problem After AC Power Dropped	pawl	Hardware	5	November 13, 2016 07:08
Problem using AMI 3D	calaba	OpenFOAM Running, Solving & CFD	0	July 27, 2016 07:30
Gambit - meshing over airfoil wrapping (?) problem	JFDC	FLUENT	1	July 11, 2011 06:59
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 07:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 20:13

All times are GMT -4. The time now is 03:44.