|
[Sponsors] |
![]() |
![]() |
#1 |
Member
Jan Potac
Join Date: Aug 2009
Posts: 30
Rep Power: 17 ![]() |
I am having a domain with an outlet to water. Water enters the domain through the inlet, fills partially the domain and leaves through the outlet. Part of the outlet patch is flooded by water from outside thus influences the outflow. I have translated the geometry so the water level outside the outlet corresponds to 0 m level. However, I cannot figure out the correct BCs for the outlet from the tutorials. It should involve a hydraulic pressure, isn't it? I have tested for example phaseHydrostaticPressure but unsure it is the right way.
Inlet: U: flowRateInletVelocity p_rgh: fixedFluxPressure alpha.water: fixedValue Outlet: U: zeroGradient p_rgh: prghPressure alpha.water: zeroGradient Any suggestions? (OpenFOAM 5, interFoam) |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
not outflow at outlet in interFoam | deniggo | OpenFOAM | 15 | May 17, 2022 06:06 |
Outlet boundary condition for wave flume with interFoam solver | Arnoldinho | OpenFOAM | 9 | July 10, 2018 05:15 |
changing velocity (outlet) BC to pressure outlet | majid_kamyab | FLUENT | 7 | October 22, 2014 11:50 |
InterFoam alpha solution for a centrifuge outlet diverges into non-physical fog | kimrj | OpenFOAM Running, Solving & CFD | 0 | April 10, 2014 04:46 |
Pipe Junction with interFoam Pressure Bounday Fails | mgdenno | OpenFOAM | 8 | April 5, 2013 09:39 |