 |
 |
 |
|
|
|
[Sponsors] | ||||
June 21, 2017, 04:33
|
Starting compressible flow simulation
|
#1 |
|
New Member
Innduk Suh
Join Date: Jun 2017
Posts: 1
Rep Power: 0  |
Hi. I usually simulate incompressible case so friendly with incompressible solvers.
but this time I have to simulate compressible flow (air injection to a tank filled with water). before starting the complex main problem, I want to simulate easier case such as air injection to the empty tank without outlet flow(air just inject to sealed tank until the inlet pressure reaches 250 atm). which solver should i use for the case? is there any similar tutorial? |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Some questions about flow boiling simulation in Fluent | beastieboys6 | FLUENT | 8 | November 21, 2017 00:47 |
| Compressible flow simulation | chiragsvnit | CFX | 0 | August 11, 2016 11:04 |
| starting compressible flow from incompressible flow results | mihaipruna | OpenFOAM Running, Solving & CFD | 2 | December 3, 2012 11:02 |
| Compressible flow Simulation in CFDesign | krishna_msrit | Autodesk Simulation CFD | 1 | September 10, 2012 00:00 |
| how to set BC for compressible flow target mass flow rate | foolboy007 | FLUENT | 1 | April 4, 2012 04:24 |
Linear Mode
