|
[Sponsors] |
![]() |
![]() |
#1 |
Member
jeanpinto24@hotmail.com
Join Date: Feb 2017
Posts: 44
Rep Power: 9 ![]() |
When using the sonicFoam solver (laminar type) using my own mesh, I throw the following error that does not allow me to run the simulation:
FOAM FATAL ERROR: Attempt to cast type patch to type symmetryPlane. My geometry has an input of greater measures and two outputs of equal measure. |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Fumiya Nozaki
Join Date: Jun 2010
Location: Yokohama, Japan
Posts: 266
Blog Entries: 1
Rep Power: 19 ![]() |
This error occurs when there is a discrepancy between patch type (patch) specified in the boundary file
and boundary condition type (symmetryPlane) specified in each field file. You might want to check the boundary file and change the patch type from patch to symmetryPlane. Best regards, Fumiya
__________________
[Personal]
|
|
![]() |
![]() |
![]() |
Tags |
sonicfoam |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Creating New Solver: For particle-laden compressible jets | sankarv | OpenFOAM Running, Solving & CFD | 17 | December 3, 2014 20:41 |
OpenCL linear solver for OpenFoam 1.7 (alpha) will come out very soon | qinmaple | OpenFOAM Announcements from Other Sources | 4 | August 10, 2012 12:00 |
Creating New Solver: For particle-laden compressible jets | sankarv | OpenFOAM | 0 | April 4, 2010 19:06 |
why the solver reject it? Anyone with experience? | bearcat | CFX | 6 | April 28, 2008 15:08 |
Incompressible viscous stress in sonicFoam | vitke | OpenFOAM Running, Solving & CFD | 0 | September 8, 2007 18:44 |