|
[Sponsors] |
February 14, 2017, 12:43 |
Fail to set swirl flow by four pipe
|
#1 |
New Member
TeiGyou
Join Date: Oct 2016
Location: Tokyo,Japan
Posts: 20
Rep Power: 9 |
Hello, everyone
I have tried to ask some questions about how to realize the swirl flow in inlet. But until now I still can not get the proper answer. So I plan to create a physical model to help to realize the swirl flow in inlet. As you can see in the picture, I set four pipes in the top of the cylinder. But when I ran it, the flow through small pipe enters into cylinder and become straight line no matter how much the speed of flow. I am very confused for it. Could anyone here help me? Is there anything wrong in my setting. Thank you very much. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
setup problems - LES pipe flow with cyclic BC (1) and direct mapped inlet (2) | florian_krause | OpenFOAM | 22 | June 13, 2013 21:25 |
swirl flow | rvndr | FLUENT | 10 | May 30, 2012 02:53 |
How to set the model for Fluid-solid flow in pipe | Fishburn | FLUENT | 0 | May 11, 2012 13:02 |
how to set BC for compressible flow target mass flow rate | foolboy007 | FLUENT | 1 | April 4, 2012 03:24 |
steam flow in a pipe driven by a pressure gradient between inlet and outlet | SalvoCalvo | COMSOL | 0 | March 11, 2010 06:52 |