Strange Behaviour of Free Surface

talatgokcer · January 27, 2016, 06:12

Helllo,

I'm using interfoam for solving multiphase ship flow.

I simulated DTC-Hull tutorial with only changing blockMesh characteristics and numerical schemes.

Unfortuanetly, I had werid elevations near outlet. You can see the free surface below.

Here my boundary conditions and system files.

Thank you.

freesurface.jpg

Artur · March 13, 2016, 10:02

Hi,

Always nice to see other people doing ship flow calculations

About your case, it seems to me the only thing you changed was adding the "interfaceCompression" scheme in lieu of the linear which was used in the tutorial? There's been plenty of discussion about that bit of OpenFOAM, if they removed it from the tutorial then perhaps it's worth trying your case without it.

I take it you're using 3.0, unfortunately I haven't ran any free surface flow simulations in it yet so can't say for sure whether I'd recommend trying to make interfaceCompression work or leaving it out in the long run.

All the best,

A

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to capture free surface cells?	MichaelVS	FLUENT	1	June 10, 2015 03:18
Floating dok on waves: free surface divergence	Galchenko	CFX	3	September 11, 2014 19:04
free surface problem with capillary effect	rabbitmelon	CFX	25	August 16, 2013 04:05
Multiphase flow. Dispersed and free surface model	Luis	CFX	8	May 29, 2007 19:13
Modeling Free Surface Flows	Elliot Schwartz	Main CFD Forum	5	August 25, 1998 22:03

March 13, 2016, 10:02		#2
Artur Senior Member Artur Join Date: May 2013 Location: Southampton, UK Posts: 372 Rep Power: 20	Hi, Always nice to see other people doing ship flow calculations About your case, it seems to me the only thing you changed was adding the "interfaceCompression" scheme in lieu of the linear which was used in the tutorial? There's been plenty of discussion about that bit of OpenFOAM, if they removed it from the tutorial then perhaps it's worth trying your case without it. I take it you're using 3.0, unfortunately I haven't ran any free surface flow simulations in it yet so can't say for sure whether I'd recommend trying to make interfaceCompression work or leaving it out in the long run. All the best, A