 |
 |
 |
|
|
|
[Sponsors] | ||||
April 29, 2015, 10:03
|
problems in running icoFoam for a 3D syringe
|
#1 |
|
New Member
Tingting
Join Date: Mar 2015
Posts: 4
Rep Power: 11  |
Hey guys,
I'm using the solver icoFoam to simulate the flow in a syringe. the geometry an mesh is done with salome. after the first time step, the simulation breaks down (you can see it in the picture)... so whats the problem? the mesh? thanks for helping 
|
|
|
|
|
|
April 30, 2015, 03:28
|
|
#2 |
|
Senior Member
Join Date: Jan 2015
Posts: 150
Rep Power: 11 |
Courant number is to high. Try to decrease the timestep
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems Running Seakeeping Analysis in Headwave | JeffStrath | STAR-CCM+ | 0 | April 28, 2015 15:37 |
| Problems with icoFoam | bego | OpenFOAM | 1 | November 16, 2009 06:01 |
| Statically Compiling OpenFOAM Issues | herzfeldd | OpenFOAM Installation | 21 | January 6, 2009 10:38 |
| Error while running icoFoam OpenFOAM15 | skabilan | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 01:04 |
| Problems of running the parallel computations | lorraine | FLUENT | 17 | July 6, 2007 09:08 |
Linear Mode
