 |
 |
 |
|
|
|
[Sponsors] | ||||
October 14, 2014, 09:15
|
dynamic mesh with snapped mesh
|
#1 |
|
Member
Kapa Lilla
Join Date: Mar 2009
Location: Bruxelles, Belgium
Posts: 57
Rep Power: 17  |
Dear All,
I wonder if there is a way to use mesh refinement for a mesh produced by snappyHexMesh which contains not just hexa elements. Right now I get always an error from hexRef8.C that some of my cells has less than 8 vertices and my simulation is aborting. I wonder if this can be circumvented somehow, even with disabling the refinement for such cells. An other question: do anyone know if the extended version of OF can handle non-hexa meshes for refinement? Thank you in advance, Lilla |
|
|
|
|
|
October 14, 2014, 10:54
|
|
#2 |
|
Member
Kapa Lilla
Join Date: Mar 2009
Location: Bruxelles, Belgium
Posts: 57
Rep Power: 17 |
In case of interest I managed to solve the problem with the help of the following tread:
http://www.cfd-online.com/Forums/ope...efinement.html I was just not looking for the right keywords, so it seems. Best, Lilla |
|
|
|
|
|
 |
| Tags |
| polyhedra, refinement, snappy hex mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dynamic Mesh on Pintle type injector. | herntan | FLUENT | 16 | September 4, 2020 09:27 |
| Dynamic mesh is not getting updated. | cardio | FLUENT | 1 | May 20, 2014 09:41 |
| [ICEM] Dynamic mesh setup with ICEM | David121284 | ANSYS Meshing & Geometry | 0 | April 11, 2014 05:19 |
| Dynamic Mesh "Shadow Wall" | thezack | FLUENT | 0 | June 4, 2013 23:09 |
| dynamic mesh for drop interface | IndrajitW | FLUENT | 0 | March 30, 2013 09:03 |
Linear Mode
