PatchInjection crashes in parallel

marcomacchi · August 12, 2014, 09:54

Dear all,

I am simulating a flow with the lagrangian solver sprayFoam. If I inject particles with the coneInjection model I can run in parallel my case, but if I use the patchInjection model it crashed at the beginning, even though it works in serial. I thought that the problem was that my domain was cut exactly where the injector was but I verified that is not. Does someone have the same problem of know how to fix this?

Thanks,
Marco

wenxu · March 7, 2016, 10:16

I also encounter the same problem. Have you solved your problem? Could you tell us? Thank you very much!!!

Best regards,
Xu

Scram_1 · April 23, 2018, 12:21

Hello everyone,
Has anyone solved this issue? Even I'm facing a similar issue in that, my case runs in serial mode but crashes after a few iterations in parallel when the preferred injection mode is patchInjection.

Best,
Scram_1

August 12, 2014, 09:54	PatchInjection crashes in parallel	#1
marcomacchi New Member Marco Macchi Join Date: May 2014 Posts: 4 Rep Power: 12	Dear all, I am simulating a flow with the lagrangian solver sprayFoam. If I inject particles with the coneInjection model I can run in parallel my case, but if I use the patchInjection model it crashed at the beginning, even though it works in serial. I thought that the problem was that my domain was cut exactly where the injector was but I verified that is not. Does someone have the same problem of know how to fix this? Thanks, Marco

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
simpleFoam parallel	AndrewMortimer	OpenFOAM Running, Solving & CFD	12	August 7, 2015 19:45
Parallel runs with sonicDyMFoam crashes (works fine with sonicFoam)	jnilsson	OpenFOAM Running, Solving & CFD	0	March 9, 2012 07:45
SnappyHexMesh OF-1.6-ext crashes on a parallel run	norman1981	OpenFOAM Bugs	5	December 7, 2011 13:48
Moving mesh crashes in parallel (1.5-dev)	jploz	OpenFOAM Programming & Development	8	October 21, 2009 18:22
Solver crashes (PVM parallel)	Marco Müller	CFX	2	February 4, 2009 03:51

March 7, 2016, 10:16		#2
wenxu Senior Member Freedom Join Date: May 2014 Posts: 209 Rep Power: 13	I also encounter the same problem. Have you solved your problem? Could you tell us? Thank you very much!!! Best regards, Xu

April 23, 2018, 12:21		#3
Scram_1 Member Join Date: Oct 2015 Posts: 63 Rep Power: 11	Hello everyone, Has anyone solved this issue? Even I'm facing a similar issue in that, my case runs in serial mode but crashes after a few iterations in parallel when the preferred injection mode is patchInjection. Best, Scram_1