|
[Sponsors] |
Change matchTolerance of AMI Interface in OF21 |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 30, 2014, 04:15 |
Change matchTolerance of AMI Interface in OF21
|
#1 |
New Member
Join Date: Feb 2014
Posts: 1
Rep Power: 0 |
Hi Foamers,
does somebody know how to interpret the matchTolerance in OF21? What ist the unit of the matchTolerance? [m]? I have an Interface between the impeller and the volute of a centrifugal pump. I'm trying to investigate the effects of changing the matchTolerance. Interface_1 { type cyclicAMI; nFaces 728; startFace 2733894; matchTolerance 0.0001; neighbourPatch Interface_2; transform noOrdering; } I've changed the values (from 1e-1 to 1e-12) but there is no change in my results (e.g. Head vs. Time). Does somebody know where to change this value (except in polyMesh/boundary) or what matchTolerance in OF exactly means? Thanks in advance! Last edited by abako; April 30, 2014 at 09:06. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
slip boundary condition within an AMI interface | louisgag | OpenFOAM Running, Solving & CFD | 0 | November 26, 2013 05:28 |
mixerVesselAMI2D's mass is not balancing | sharonyue | OpenFOAM Running, Solving & CFD | 6 | June 10, 2013 09:34 |
Stage Interface Without Frame Change | Vikram | CFX | 2 | October 21, 2005 04:55 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |