|
[Sponsors] |
April 26, 2014, 10:49 |
Problem with capillary force
|
#1 |
New Member
Join Date: Jan 2014
Posts: 26
Rep Power: 12 |
Hi there,
So i am trying to simulate a rotating vessel with capillary force . The results are fine up to a certain point , but then the time step increases dramatically and when i check the results in paraFoam, the results seem really strange . I ran the same simulation without the capillary force and there was no problem . Does anybody know what the problem is ? by the way capillary angel is 45 degrees |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
lift force problem with Flow around a cylinder | Scabbard | OpenFOAM Running, Solving & CFD | 2 | July 21, 2014 04:19 |
CFX Total force problem | momozzzz | CFX | 1 | July 15, 2011 09:54 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
Two-phase air water flow problems by activating Wall Lubrication Force | challenger85 | CFX | 5 | November 5, 2009 05:44 |
Urgently Need the code of Lift force and VM force | Kai Yan | Main CFD Forum | 0 | July 16, 2008 07:07 |