|
[Sponsors] |
hull foils high Fr Free Surface problems with LTSInterFoam |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
laurentL
Join Date: Oct 2011
Location: new caledonia
Posts: 73
Rep Power: 15 ![]() |
Dear all,
i try to run simulation with OF 2.2.1 LTSInterFoam at 6 or 12m/s and i get two problems: -some bad little waves all around -a very high velocity in air, where this object is. any idea or directions to make thinks better will be very appreciate! thanks be advance. Laurent test07_small800.jpg 9000tstp_small.jpg Hi again, part of solution, was to reduce cAlpha to 0.5, no more little wave, but no more ventilation to! what solver, (interFoam, cavitatingFoam ...) specialist would subject to predict the ventilation of a free surface piercing foil??? thanks for helping Last edited by laurent98; January 13, 2014 at 08:03. Reason: resolving evolution |
|
![]() |
![]() |
![]() |
Tags |
foil, free surface, high fr, hull, ltsinterfoam |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
free surface around a ship hull | Stephy | OpenFOAM Running, Solving & CFD | 12 | April 24, 2012 02:12 |
CFX convergence issues with free surface | adenlan | CFX | 3 | September 2, 2011 07:43 |
Linear analytical solution oto the 2D free sloshing water surface elevation | bearcat | Main CFD Forum | 7 | August 5, 2011 21:13 |
Convergence speed in free surface simulations | Chebeba | CFX | 13 | July 23, 2009 14:08 |
BC for free surface | pilar | FLUENT | 3 | January 14, 2004 08:36 |