 |
 |
 |
|
|
|
[Sponsors] | ||||
December 17, 2013, 12:20
|
Problem run simpleFoam
|
#1 |
|
Member
ynos
Join Date: Jan 2011
Posts: 39
Rep Power: 15  |
Hi there
I am trying to run an airfoil with the same BC that OpenFoam/tutorials/motorbike but my forces results are crazy. Maybe the BC are not good ....i dont know where is the problem. I used rotateMesh "(0 1 0)" "(0 0 1)" Can somebody help me? Attached the case Thanks in advanced Best regards Simón Last edited by ynos; December 17, 2013 at 12:39. Reason: forget comment |
|
|
|
|
|
December 18, 2013, 12:13
|
|
#2 |
|
Member
ynos
Join Date: Jan 2011
Posts: 39
Rep Power: 15 |
I resolved the problem. The mesh was not good. I improved the mesh in addLayers and run ok
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| topoSet simpleFoam parallelized run error | HakikiCanakkaleli | OpenFOAM Pre-Processing | 5 | October 5, 2018 11:52 |
| Problem in simpleFoam airFoil2D forceCoeffs | junkie71189 | OpenFOAM Running, Solving & CFD | 31 | March 11, 2017 22:56 |
| Help Troubleshooting simpleFoam problem on Harpoon made mesh | lhcamilo | OpenFOAM Bugs | 1 | February 18, 2009 08:11 |
| transient problem run in steady state | luigi | FLUENT | 4 | March 13, 2008 07:54 |
| Problem on Parallel Run Setup | Hamidur Rahman | CFX | 0 | September 23, 2007 18:11 |
Linear Mode
