 |
 |
 |
|
|
|
[Sponsors] | ||||
September 28, 2013, 05:50
|
Microchannel using rhoCentralFoam
|
#1 |
|
New Member
M. Sabouri
Join Date: Nov 2011
Posts: 24
Rep Power: 15  |
Hi,
I'm using rhoCentralFoam for the gas flow in microchannels. I set the pressure value at the outlet, but the results show that it is not sat. In fact, the last two cells in the channel have an odd behavior. As can be seen in the figure, the pressure increases in these two cells. This figure shows the pressure distribution on the channel centerline with the B.C. : Pi=150kPa and Po=50kPa. Does anybody know what is wrong with the test case? Thanks. MicroChannel.zip |
|
|
|
|
 |
| Tags |
| micro channel, rhocentralfoam |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rhoCentralFoam transport equation | JoaoDMiranda | OpenFOAM Programming & Development | 29 | July 5, 2024 09:38 |
| dynamic mesh refinement and rhoCentralFoam | ChrisA | OpenFOAM Running, Solving & CFD | 1 | March 21, 2013 09:00 |
| calculate a nozzle flow using rhoCentralFoam | hg2lf | OpenFOAM | 0 | October 25, 2012 22:26 |
| rhoCentralFoam solver with Slip BCs fails in Parallel Only | JLight | OpenFOAM Running, Solving & CFD | 2 | October 11, 2012 22:08 |
| Modeling a microparticle flowing through a microchannel | tiho_bg | FLUENT | 0 | February 8, 2012 11:22 |
Linear Mode
