no floatingObject patch generated in tutorial "floatingObject"

yejungong · August 8, 2013, 07:32

Hello,

I have runned the floatingObject tutorial using OpenFOAM-1.6-ext. But in ParaView, there is no patch called floatingObject? And the free surface is a line in the xz plane, not a fold line as expected.

There is no error message showing up totally.

The below log.subsetMesh looks fine also.
------------------
Create time

Create mesh for time = 0

Reading cell set from c0

Adding exposed internal faces to patch floatingObject

Number of cells in new mesh : 94848
Number of faces in new mesh : 291280
Number of points in new mesh: 101694
Writing subsetted mesh and fields to time 0

End
-------------------

Should I do some postprocessing?

Best wishes,
Yejun

yejungong · August 8, 2013, 22:43

I got it. The ext version of this tutorial is not quite right. It runs well in 1.7.1.

August 8, 2013, 07:32	no floatingObject patch generated in tutorial "floatingObject"	#1
yejungong New Member Yejun Gong Join Date: Mar 2009 Posts: 21 Rep Power: 18	Hello, I have runned the floatingObject tutorial using OpenFOAM-1.6-ext. But in ParaView, there is no patch called floatingObject? And the free surface is a line in the xz plane, not a fold line as expected. There is no error message showing up totally. The below log.subsetMesh looks fine also. ------------------ Create time Create mesh for time = 0 Reading cell set from c0 Adding exposed internal faces to patch floatingObject Number of cells in new mesh : 94848 Number of faces in new mesh : 291280 Number of points in new mesh: 101694 Writing subsetted mesh and fields to time 0 End ------------------- Should I do some postprocessing? Best wishes, Yejun

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
AMI speed performance	danny123	OpenFOAM	21	October 24, 2020 05:13
[GAMBIT] periodic faces not matching	Aadhavan	ANSYS Meshing & Geometry	6	August 31, 2013 12:25
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 05:04
chtMultiRegionFoam Tutorial	m.nichols19	OpenFOAM	12	September 9, 2010 12:56
problem with new OF170 using floatingObject tutorial example	anmartin	OpenFOAM Running, Solving & CFD	1	July 1, 2010 02:09

August 8, 2013, 22:43		#2
yejungong New Member Yejun Gong Join Date: Mar 2009 Posts: 21 Rep Power: 18	I got it. The ext version of this tutorial is not quite right. It runs well in 1.7.1.