[HHOS]

Hello;

I have just started to use HelyxOS to see if it's worthy to get into it and use for many purposes instead of Fluent, but I'm not able even to run a simple case.

The main purpose is to do a fluent mesh and then to convert it. I have done it already and I can see it properly with paraFoam, so, the mesh is OK.

What I have is the case folder where there is:

Case Folder

Constant

polyMesh (with all the converted files)

system

controlDict
fvSchemes (almost empty)
fvSolution (almost empty)

I load the case with HelyxOS; I see the mesh and I have access to the Case Setup tab. I set everything up and when I click on Start to run the case, this is all I get:

First it saves a lot of files related to the case setup.
Then I get:
Exception in thread "Thread-4" java.lang.NullPointerException

at eu.engys.core.project.system.SystemFolder.save(sys temFolder.java:124)
at eu.engys.core.project.ProjectWriter.write(ProjectW riter.java:62)
at eu.engys.helyx.gui.Controller$20.run(Controller.ja va:288)
at java.lang.Thread.run(Thread.java:722)

And it gets stuck there... nothing ever happens after that.

Any advice or comment whould be very helpfull.

Thank you very much!!