 |
 |
 |
|
|
|
[Sponsors] | ||||
Modify specific heat ratio/polytropic index in OpenFOAM |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 1, 2013, 13:12
|
Modify specific heat ratio/polytropic index in OpenFOAM
|
#1 |
|
New Member
Ah Cai
Join Date: Dec 2010
Location: Malaysia
Posts: 16
Rep Power: 16  |
Hi Foamers,
I am using, Openfoam 2.0.x, dieselEngineFoam to simulate diesel engine with a reduced mechanism. I found out that the default gamma value (specific heat ratio) in Openfoam is 1.37. The gamma value that I want for my simulation is 1.36. Any hints on how to modify this gamma value to the value I desire? Thanks in advance for any hints. Regards, ahcai |
|
|
|
|
|
| Tags |
| diesel engine, specific heat |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Radiation interface | hinca | CFX | 15 | January 26, 2014 18:11 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
| modify specific heat ratio in OpenFOAM | Gitesh P | OpenFOAM Running, Solving & CFD | 0 | June 25, 2012 06:52 |
| error message | cuteapathy | CFX | 14 | March 20, 2012 07:45 |
| Integral specific heat | Steve Amphlett | Main CFD Forum | 0 | August 25, 2000 10:51 |
Linear Mode
