|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Harry
Join Date: Oct 2022
Posts: 1
Rep Power: 0 ![]() |
Hi all,
I am wondering if anyone can point me in the right direction to incorporate boundary layer suction into OpenFoam. I am working of the motorcycle tutorial using simplefoam. Would setFieldsDict be the right way to set this? I can either set the boundary along the entire mesh, or have the mesh be hollow and than only have a different boundary condition at the wall edge, however this will need to be a circular boundary. I know there is the dam break tutorial but that is in 2d. If you can point me in the right direction that would be great! Thanks all! |
|
![]() |
![]() |
![]() |
Tags |
incomprehensible, simplefoam |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Simulating boundary layer suction | HHK | FLUENT | 1 | May 10, 2018 09:19 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 00:00 |
[snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |