 |
 |
 |
|
|
|
[Sponsors] | ||||
How to applied cyclic boundary condition in zigzag channel? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 20, 2020, 04:07
|
How to applied cyclic boundary condition in zigzag channel?
|
#1 |
|
New Member
Duc Anh
Join Date: Dec 2018
Posts: 22
Rep Power: 8  |
I have a zigzag channel in the figure below. Instead of applying cyclic boundary with 2 faces are beginning and ending of every cycle, I want to use just 2 faces are beginning and half-cycle (red line in the figure). Do you have any suggestions and OpenFoam can do that? Thank you so much! |
|
|
|
|
|
March 20, 2020, 04:13
|
How to applied cyclic boundary condition in zigzag channel
|
#2 |
|
New Member
Duc Anh
Join Date: Dec 2018
Posts: 22
Rep Power: 8 |
hi, foamer
I have a zigzag channel in the figure below. Instead of applying cyclic boundary with 2 faces are beginning and ending of every cycle, I want to use just 2 faces are beginning and half-cycle (red line in the figure). Do you have any suggestions and OpenFoam can do that? Thank you so much! |
|
|
|
|
|
|
| Tags |
| cyclic boundary condition, zigzag channel |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Inlet Boundary Condition for Open Channel type flow | Akshay_11235 | OpenFOAM Running, Solving & CFD | 12 | April 15, 2024 05:05 |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
| Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 18:38 |
| Channel Boundary Condition | FlyBob91 | OpenFOAM Pre-Processing | 1 | October 19, 2016 10:06 |
| Error - Solar absorber - Solar Thermal Radiation | MichaelK | CFX | 12 | September 1, 2016 06:15 |
Linear Mode
