 |
 |
 |
|
|
|
[Sponsors] | ||||
September 5, 2017, 10:09
|
Understanding slip boundary condition
|
#1 |
|
Senior Member
Przemek
Join Date: Jun 2011
Posts: 249
Rep Power: 16  |
Hi All,
As I properly understand, the slip BC should work like that it sets at the wall the values of velocity flow field taken from the cells adjacent to the wall, with a restriction that it takes only the component of the velocity that is tangential to the wall, am I right?
__________________
best regards pblasiak |
|
|
|
|
|
September 5, 2017, 10:54
|
|
#2 |
|
Senior Member
Przemek
Join Date: Jun 2011
Posts: 249
Rep Power: 16 |
If I am right, can anybody point out the file where it is implemented?
__________________
best regards pblasiak |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
| Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 14:55 |
| Problem in setting Boundary Condition | Madhatter92 | CFX | 12 | January 12, 2016 05:39 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 07:28 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
Linear Mode
