Solver buoyantBoussinesqPimpleFoam without turbulence

jrsilvio_ver · February 23, 2014, 17:44

Dear, good night.
I'm working with the dreaded buoyantBoussinesqPimpleFoam and am facing difficulties in removing the turbulence model. I tried changing the RASProperties so:

__________________________________________________ ___________________________
RASModel laminar;

turbulence off;

printCoeffs off;
__________________________________________________ ___________________________

However, it did not work. How to change the code buoyantBoussinesqPimpleFoam to fully remove the turbulence model?

Another question. The buoyantBoussinesqPimpleFoam has already incorporated the heat exchanges by radiation, including the calculation of form factors between surface? If not, how can I include this heat balance?

jrsilvio_ver · February 24, 2014, 16:39

Nobody has an interest in the subject in question?

February 23, 2014, 17:44	Solver buoyantBoussinesqPimpleFoam without turbulence	#1
jrsilvio_ver Member JuNNioR Join Date: Feb 2014 Location: Brazil Posts: 44 Rep Power: 12	Dear, good night. I'm working with the dreaded buoyantBoussinesqPimpleFoam and am facing difficulties in removing the turbulence model. I tried changing the RASProperties so: __________________________________________________ ___________________________ RASModel laminar; turbulence off; printCoeffs off; __________________________________________________ ___________________________ However, it did not work. How to change the code buoyantBoussinesqPimpleFoam to fully remove the turbulence model? Another question. The buoyantBoussinesqPimpleFoam has already incorporated the heat exchanges by radiation, including the calculation of form factors between surface? If not, how can I include this heat balance?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
different results between serial solver and parallel solver	wlt_1985	FLUENT	11	October 12, 2018 09:23
OpenCL linear solver for OpenFoam 1.7 (alpha) will come out very soon	qinmaple	OpenFOAM Announcements from Other Sources	4	August 10, 2012 12:00
Working directory via command line	Luiz	CFX	4	March 6, 2011 21:02
Two equation turbulence models solver settings	truffaldino	FLUENT	0	March 5, 2011 21:49
turbulence modeling questions	llowen	Main CFD Forum	3	September 11, 1998 05:24

February 24, 2014, 16:39		#2
jrsilvio_ver Member JuNNioR Join Date: Feb 2014 Location: Brazil Posts: 44 Rep Power: 12	Nobody has an interest in the subject in question?