|
[Sponsors] |
April 3, 2010, 16:54 |
Doubt regarding 3-D meshing of a rocket nose
|
#1 |
Senior Member
Nakul
Join Date: Apr 2010
Location: India
Posts: 147
Rep Power: 16 |
Hi,
I am new to using openFoam and hav recently set up a 3-d case. Its a simple rocket geometry, i.e, a cylinder with a leading ogive nose. I am creating a full 3-d body and the problem is that i am getting a cell at the nose tip of zero volume. Although i haven't run the case as yet but i have felt its presence while defining the blocks in blockMeshdict file. Any advice as to how to go about this zero volume cell would be highly helpful. Thanx |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
doubt in meshing: physics | jai | Main CFD Forum | 0 | May 9, 2009 08:17 |
doubt on meshing | joe | FLUENT | 2 | September 12, 2005 14:17 |
doubt on meshing a cylinder | FELIX JOE S | FLUENT | 13 | July 27, 2005 09:06 |
ProAm meshing...Doubt | Antony | Siemens | 5 | July 26, 2004 06:31 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 12:08 |